
AN EQ THAT ONLY CUTS WHEN IT NEEDS TO. 80% OFF
Dynamic EQ 2 from Initial Audio replaces static EQ moves with multiband dynamics that react only when a problem builds up, keeping warmth and punch intact.
Instances talk to each other across your DAW, so a bass can duck under the kick or a guitar bus under the vocal in three clicks, with no routing. Any band can work in stereo, mid, side, left or right.
Grab it today for $10, 80% off the regular $49.
Available as VST3, AU and AAX for Windows and Mac.

You cut the low-mids to clean up a muddy vocal and the verse sounds great, then the chorus hits and the voice feels thin. You add a high boost for air and every "S" turns into a tiny dental drill. Dynamic EQ 2 from Initial Audio is a multiband dynamic EQ built for exactly this problem. A static EQ applies the same move from the first bar to the last, while Dynamic EQ 2 reacts only when something builds up, so the warmth, clarity and punch you liked in the first place stay intact. For a limited time, you can get it for $10 instead of the regular $49, which is 80% off.
The standout feature is the inter-instance sidechain. Instances of Dynamic EQ 2 talk to each other across your DAW, so a bass can duck under the kick or a guitar bus can make room for the vocal without any routing. Load the plugin on the vocal and on the guitar bus, pick "Vocal" from the sidechain dropdown on the guitar instance, and create a band at the frequency you want to duck. It reacts only when the vocal is singing. The same trick works for carving a hole in the bass at 60 Hz every time the kick hits, which usually takes far longer to set up.
Any band can work in Stereo, Mid, Side, Left or Right, so you can keep the center focused while opening up the highs. You get 16 bands, 2x oversampling, a Full Amp mode that triggers compression from the overall signal level, and zero-cramping Low Cut, High Cut, Peak, Shelf and Tilt filters that hold up when you push them. De-essing stays smooth without the lisp, thin vocals can gain body only when the singer hits low notes, and a dynamic high-shelf cut can tame a chorus that gets too bright. With oversampling on and its linear-phase-like response, it's clean enough for mastering too.
Dynamic EQ 2 comes in VST3, AU and AAX formats for Windows and Mac, so it fits into most production setups, whether you're mixing in your bedroom or finishing tracks in a full studio. Load it on any track or bus and it's ready to work alongside the other instances in your session.
VST3, AU and AAX on Mac (macOS 10.13 or later, Apple Silicon and Intel), VST3 (64-bit) and AAX on Windows 10 and 11.
Multiband dynamic EQ that reacts only when needed
Inter-instance sidechain across your DAW, no routing
Three-click setup for ducking one track under another
16 bands for detailed, surgical EQ control
Stereo, Mid, Side, Left or Right on any band
Full Amp mode triggers compression from overall signal level
Frequency-dependent dynamic key input for targeted adjustments
Zero-cramping Low Cut, High Cut, Peak, Shelf and Tilt filters
2x oversampling for clean results, even on the master bus
Smooth de-essing that keeps vocals natural
Preset Manager for saving and recalling your favorite settings
VST3, AU and AAX for Windows and Mac Select: $€£¥
For every dollar you spend on any Deal or in the Shop, past, present or future, we'll give you back 10% of that in rewards cash that will be saved in your Rewards Wallet.